Common problems and causes after aluminum gusset ceiling installation
Time:2021-05-19
Views:5871
1. After the installation of the aluminum gusset ceiling is completed, the uppermost plate can be lifted up only by touching it lightly with the hand. This phenomenon is often caused by the workers failing to open the bayonet on the corners, and sometimes because the workers are careless, they forget the problem. So this is also one of the criteria for checking whether your aluminum gusset is hoisted.
2. After the aluminum clip in ceiling tiles is installed, the corners will be warped or the glue will be opened in less than half a month. This phenomenon cannot be generalized. There are generally two ways to install the corners. Different installation methods have different reasons for the corners.
Install the corners method 1. Use glue. A few years ago, the method of gluing edges and corners was the most common method. However, due to insufficient glue or poor glue quality during installation, some workers may cause the corners to be warped. This method is now generally used by regular decoration companies because there are too many sequelae.
Install the corner method 2. Punch holes in the wall first, align the holes in the corners with the holes in the wall, and then fix the corners on the wall with nails. The advantage of this method is that it does not use glass glue, the fixation is relatively firm, and it is not easy to fall off. But using this method to fix requires the owner to ensure that there is no problem with the wall tiles and there will be no voids. If the wall tiles are pasted with voids, the wall tiles will easily be cracked. So this party can also test the pasting technology of wall tiles.
3. After the aluminum clip in ceiling tiles is installed, it is found that there are gaps between the individual aluminum gussets. This problem is the most common problem when aluminum gusset ceilings are suspended. The cause of this phenomenon can basically be determined because the construction workers’ negligence caused the installation of the aluminum gussets to not be in place, or it may be the construction personnel’s poor skills and the installation of the keel.
4. After the aluminum clip in ceiling tiles is installed, there are gaps in a large area. It is very likely that the aluminum gusset and keel you bought are not matching products. The matching keel produced by a regular manufacturer is very tight after being buckled, and the tooth pitch of the keel and the plate is also very accurate. Take the Kingreal aluminium clip in ceiling carrier making machine as an example, the ceiling tee bar produced by this line can be perfectly matched with the drop ceiling tiles produced by the Kingreal drop ceiling tile production line.
 |
 |
Email
MR tan
Mr Tan