How to make better use of the square metal ceiling?

In the case of house decoration, even if you don’t use gypsum board for ceiling, square metal ceiling is produced by Square Metal Ceiling Machine, which is inevitable from beginning to end. In the case of installing square metal ceilings, there are some very important links to pay attention to. If you ignore it, then many injuries may occur.

Therefore, in the case of installing square metal ceiling to decorate the ceiling, everyone must pay attention to these aspects.

1.    Square metal plate fully transparent protective film

For newly upgraded square metal ceiling, layers of fully transparent protective film often appear on its surface. Before installation, you must first calculate the floor area of the lower square metal ceiling installation, how much it costs, and how much the film will be torn off.

The remaining square metal ceilings that have not been torn off the film can be retired. Therefore, you must pay attention to this point：there is no need to tear off the doorknob to relax the square metal ceilings in a moment, otherwise you will not be able to retreat.

2.    The film of the square metal ceiling must be torn off before installation

In some households, the house decoration was not selected at that time, and the film was not torn off before the square metal ceiling was installed. After the installation, the film was not easily torn off. Continue to be left behind.

3.    Mark the water circuit

Because it will involve a production process of drilling holes, then for the wall, after you have made the waterway and circuit, you must make a good mark.

In this case, this kind of area can be well avoided when drilling the hole, otherwise the hole will be punched in the cable water pipe at a later date, and it will be troublesome later.

4.    Difficulties of wall hollowing must be avoided

In fact, it is still related to the hole drilling. If the floor tiles on the wall are hollow, the floor tiles will easily crack during the second half of the hole drilling.

Therefore, before making square metal ceilings, the completion acceptance of the wall tiles must be done well.

5.    Drill deep

Drill holes 13-4cm deep, in addition to avoiding drilling into the pipeline, but also to avoid damaging the ground and waterproofing. Therefore, the depth of the hole does not need to be too deep, just 3-4cm.

6.    Design and conceptualize the location of lighting equipment vents in advance

In order to better avoid future troubles, before installing the square metal ceiling, be sure to design and conceptualize the installation location of the lighting equipment vents.

If you want to know more about the square metal ceiling, you can visit our KINGREAL website.