Hydraulic Decoiler Introduction
Time:2021-02-08
Views:2759
Large hydraulic decoiler is a special model specially developed and produced for thick and wide coil uncoiling. It is equipped with a pneumatic pressing arm, a pneumatic supporting arm, a pneumatic stop arm, a hydraulic expansion device, and a frequency converter. The main operation of the device is mainly concentrated on the panel of the electric control box and the independent operation handle.
Operation method of large hydraulic decoiler:
1. Check the tightness of each part of the large hydraulic decoiler. After confirming that it is correct, connect the external power and air source, and adjust the air source pressure at the same time.
2. On the decoiler operating electrical box, select manual operation mode.
1. Check the tightness of each part of the large hydraulic decoiler. After confirming that it is correct, connect the external power and air source, and adjust the air source pressure at the same time.
2. On the decoiler operating electrical box, select manual operation mode.
3. Through the independent operating handle button, the pneumatic pressing arm is raised, the pneumatic supporting arm is lowered, the unwinding and expanding reel is contracted, and the outer pneumatic stopper arm is raised.
4. Adjust the position of the pneumatic stop arm on the inner side according to the width of the material. When adjusting, push the adjustment handwheel inward and rotate the handwheel to adjust the position of the pneumatic stop arm on the coil side. After the adjustment is completed, the uncoiler must be loaded with the material. The center of the material is aligned with the center line of the subsequent mating machine.
5. Use a crane or a moving loading trolley to move the material onto the unwinding expansion and contraction reel, and just close to the inner side guide arm of the coil.
6. Expand unwinding and shrinking reel.
7. Lower the pneumatic pressure arm.
8. Pull out the coil material pneumatic stop arm position to adjust the lowering hand wheel, then adjust the outer coil side pneumatic stop arm position, and then lower the outer coil side pneumatic stop arm.
9. Raise the pneumatic material support arm of the coil, adjust the position of the material head by operating the uncoiling expansion and contraction reel to rotate forward and the uncoiling expansion and contraction reel to reverse to adjust the position of the material head, and cut the material packaging tape at a suitable position.
10. Manual jog forward operation, control the uncoiler to slowly release the material head, and then lead the material to the subsequent machine.
11. After the lead debugging is completed, the automatic operation mode can be selected to perform automatic uncoiling operations, and the uncoiling speed can be adjusted according to the needs.
Email
MR tan
Mr Tan